Posts Tagged ‘algae’

Why algae grows in your pool in the summer

Friday, May 27th, 2011

This is an article about algae in swimming pools and it has got graphs in it. I am sometimes accused of being a bit nerdy, I don’t know why!

Algae need light to grow, strong sunshine is algae’s best friend. Just when we are getting our pools ready for the warm summer days the daylight hours start to increase, just what the alage need. It is worth taking a look at just how the light in the UK varies throught the year.

Below is a  graph on which the blue line is daylight hours.  Note how all through June and well in to July we get 16 hours of daylight per day compared with 8 hours in winter. Twice as much daylight in summer as in winter.

The Blue line is daylight hours, the Red line sunset time, the orange line sunrise time

The next graph shows the altitude of the sun. Note how in summer when the days are 16 hours long the sun is up to 60 degrees above the horizon but in winter is barely gets above 20 degrees. The lower the altitude the more atmosphere it has to penetrate, the lower the strength of the light. The opposite in summer lots of light and lots of strength.

The higher the sun the stronger the light



That is why algae grows so much more in the summer than it does in the winter. Light = food for algea, give something twice the amount of food and it will grow twice as much.

The top four ways to kill algae in a swimming pool

Friday, August 6th, 2010

Algae growing in a swimming pool is a perenial problem for the swimming pool owner here we will examine the 4 most popular ways to get rid of it. These are

  1. Chlorine
  2. Copper
  3. Quats and Poly Quats
  4. Phosphate removal.


As we will see some of the above can be used to kill algae and some are only useful to prevent it forming in the first place. Algae can be introduced to the pool by rain, falling leaves, wind or even bathing suits transfering algae from one body of water to another. Planktonic clean water algae float on the surface of pool water while other types will attach and grow onto the pool floor or sides.  Many factors affect the development and growth rate of algae. Water temperature, sunlight, pH, mineral content and lack of chlorine residual of the pool water will all help to encouage algae development.

Chlorine.

Chlorine gets a bad press but since it was discovered that chlorine kills germs its use as a sanitiser in drinking water has saved millions of lives worldwide. Chlorine is the only chemical that acually kills algae. It acts in the same way as setting fire to the algae, it oxidises it.  When you have a bloom of green algae in your pool then by far the best thing to do it to blast it with a shock dose of unstabilised chlorine. What is not used up in killing the algae will be burnt off by the sunlight.

Copper

Copper does not kill algae it disrupts its metabolism and stops it reproducing. Copper can be introduced in to the water in two main ways as a chemical or by an ionizer. Too much copper can cause stains on concrete pools so chemicals that contain copper also contain a chelating agent, a stabiliser, that does not allow too much copper in to the water at any one time.

Quats and Poly Quats.

Quat is the short hand term for a family of chemicals called quaternary ammonium compounds.  Again they do not kill algae they disrupts its metabolism. Quats are short lived and you need to keep adding them to the water to keep algae at bay. They are a cheap chemical but they affect the surface tension of the water and cause it foam, foaming is perfectly normal but many pool users don’t like it. A high level of Quat will kill off an algae bloom but even so chlorine is still better for this so quats are usually used at lower levels as a preventative. Poly Quats or polymeric quaternary ammonium compounds are long chains of Quats and although they are more expensive they last longer and don’t cause foaming of the water. These are marketed as Long Life Algicides and are the popular form of Algicide in liquid form.

Phosphate Removers

All of the above chemicals act by meeting the algae head on and killing it. Phosphate removers act in a more subtle way. Algae must have phosphates present to be able to grow. Remove phosphates from the water and the algae are starved to death. Compounds of Lanthanum are used to react with the phosphate and precipitate it out where it is picked out by the filter.

All of the above methods are good at killing or preventing algae and you can mix and match any of them or even use all four methods.

Does using Bayrol Soft & Easy mean saying goodbye to Chlorine?

Friday, August 6th, 2010

PoolStore’s recommended non-chlorine alternative is Bayrol Soft and Easy.  For a comprehensive article on all the various non-chorine alternatives read our help and advice section on the main website. We like the Bayrol product because it is easy to use but it has a few shortcomings and this article will explain them.

Firstly let’s just re-cap on why you put chemicals in your pool. Two reasons. (1) to kill bacteria. (2) to kill or prevent algae. Bacteria and algae are living organisms, organic material and the way to kill them is to oxidise them. Oxidising organic material is the same as if you set fire to it. When you burn something it reacts with oxygen from the air and becomes something else, in the case of bacteria being oxidised it becomes dead.

So to kill bacteria you must add an oxidising chemical to the water and the favourite chemical to do this the world over is chlorine. But if you don’t want to use chlorine you could use a peroxide type chemical. The best known peroxide is hydrogen peroxide, used as rocket fuel and to bleach hair. In swimming pool chemicals they come in the form of persulphates and one of the two sachets in soft & easy contains a persulphate oxidiser that does a very good job of killing bacteria. Persulphate oxidisers are also know as Active Oxygen.

Although peroxides are a good oxidiser for killing bacteria, algae is a different matter. Peroxides are not a strong enough oxidiser to kill algae. Fortunatly there is more than one way to kill algae. One way is to add a chemical called a poly-quat to the water.  The other sachet in Soft & Easy contains a poly-quat  to attack the algae because the peroxide can not do it.

The problem that Soft & Easy has is that if you get an aggressive attack of algae the poly-quat part of it can not cope with the influx of algae and before to long your pool will start to look green. Algae reproduce at an alarming rate and if your pool is green you have live algae and need to kill it straightaway. The only way to kill algae quickly is with a shock dose of unstabilised chlorine. Provided you put enough in, the chlorine will kill the algae in hours and what is not used up in killing will be burnt off by the sun.

So it is not at all uncommon for a pool treated with Soft & Easy to go green from time to time so you will need to have some shock chlorine in reserve to kill off any algae that the copper can not cope with.

Chlorine Shock

Shock (unstabilised) Chlorine

bayrol soft and easy

Bayrol Soft & Easy

Got Algae? Now you can starve it to death!

Wednesday, March 24th, 2010

Algae is the perennial problem for swimming pool owners.  For years we have struggled to rid it from our swimming pools but it keeps coming back. PoolStore have found a new way to keep it away for good.

 

If your pool is green then it is a little too late for this treatment, you probably need the treatment described here

 

Algae is a living organism whose spores blow in the wind and once in your pool they can multiply very quickly. There have always been two ways to keep algae from forming in your pool.  One is to keep the chlorine level above about 3ppm and the other is to use a traditional algicide. The chlorine will kill the algae on contact but you have to keep a high level ALL the time. Let it drop for a day or two and you could find you have a growth in your pool. Long Life Algicides are a better method than Chlorine because they stay in the water for up to 3 months at a time and kill aglae as it enters the water but if you get a lot of spores blow in it can be overwhelmed.

 

We said earlier that algae is a living organism. Living things need food to eat. Algae eats phosphate for breakfast, lunch and dinner. The more phosphate in water the more algae will love it in there and grow and grow. Phosphate gets in your pool from your tap water.  Some areas have very high phosphate in their water supply. So, if we could remove the phosphate from the water the algae will have no food and therefore die. That is exactly what Starver does.

 

Starver contains a chemical that combines with phosphates and forms a suspension in the water. Filtration and clarifiers will pick this suspension out of the water leaving it phosphate free. No phosphate = No algae.

 

Theoretically one treatment should last forever but unfortunately phosphate finds a way of getting back in your water either from topping from the tap or from rain run off . So you do need to test your water regularly to check your levels and add a bit more starver if necessary. A test kit for phospate levels is included with every bottle of Starver.

 

If you have very high phosphate levels then use Bulk Starver first. This brings the high levels down to more managable levels and then regular Starver can take over.